Current Position:Home > Product > Magnetostrictive and Magnetic Displacement Sensor
Magnetostrictive and Magnetic Displacement Sensor
Product Name:MF Corrosion Resistant Magnetostrictive Displacement Sensor
Product Summary:
Product Summary:
Magnetostrictive sensors are non-contact and never wear out. It has the advantages of high resolution, high precision, high stability, high reliability, fast response time and long working life. Sensors do not need to be re-calibrated or regularly maintained
Download:
Global Online Advisory
- Product Overview
- Technical Parameters
- Size selection
一. Introduction of MF anti-corrosion magnetostrictive displacement sensor:
Magnetostrictive sensors are non-contact and never wear out. It has the advantages of high resolution, high precision, high stability, high reliability, fast response time and long working life. Sensors do not need to be re-calibrated or regularly maintained
二. Standard parameters of MF anti-corrosion magnetostrictive displacement sensor:
1. Measuring range: 30～5000mm
2. Supply voltage: +12VDC～+24VDC
3. Output form/analog signal: current 4-20mA and 0-20mA, voltage 0-5V and 0-10V, digital signal: RS485, MODBUS
4. Load capacity: voltage signal output load ≥ 4KΩ current signal output load ≤ 500Ω
5. Non-linear error: ≤0.05%FS
6. Repeatability error: ≤0.0005%FS
7. Resolution: ≤0.038mm
8. Hysteresis: ≤0.001%FS
9. Temperature stability: ≤0.002%/℃
10. Working current: ≤16mA
11. Working pressure: continuous working pressure ≤ 35MPa (MTL built-in high pressure series)
12. Working temperature: T1: -20～+55℃, T2: -40～+80℃, T3: -50～+125℃
13. Measuring rod material: 0Cr18Ni9 (304) 316 stainless steel (special customization)
14. Electronic warehouse shell material: 0Cr18Ni9 (304) 316 stainless steel (special customization)
15. Lead mode: high temperature resistant twisted pair shielded cable (default length: 1m, can also be provided according to user requirements)
16. Shell protection grade: IP65
三. MF anti-corrosion magnetostrictive displacement sensor wiring method:
Before wiring, please check whether the power supply meets the requirements of +24VDC, and the output power of the power supply must be greater than the total power consumption of the product, calculated according to different ranges of each sensor ≤95mA. If the power supply cannot meet the requirements, please replace the power supply to ensure that the sensor can work normally.
Analog signal output wiring mode of MF anti-corrosion magnetostrictive displacement sensor:
1. The wiring method of the waterproof connector straight out:
The sensor has five contacts: power supply positive (brown), power supply negative (black), signal output positive (blue), signal output negative (white), housing ground (shielded wire)
Digital signal output wiring mode of MF anti-corrosion magnetostrictive displacement sensor:
1. The wiring method of the waterproof connector straight out:
The sensor has five contacts: positive power supply (brown), power ground (black), RS485A (blue), RS485B (white), housing ground (shielded wire)
四. MF anti-corrosion magnetostrictive displacement sensor installation dimension drawing:
五. Magnetostrictive Displacement Sensor Selection Guide
